Isuzu Fault Code
Free · no signupP1271
Accelerator Fault. Engine stays at idle; no throttle response.
System
Throttle
Symptom
Accelerator Fault. Engine stays at idle; no throttle response.
Diagnosis & fix steps
Accelerator Pedal Position (APP) Sensor 1/2 Correlation.
LOGIC: The ECM detects a mismatch between the two signals (Sensor 1 and Sensor 2) in the pedal assembly.
ACTION: Use a scan tool to monitor the live percentage of both APP sensors while slowly depressing the pedal.
FIX: Clean the sensor connector pins with electrical contact cleaner. If the mismatch persists, replace the Accelerator Pedal Assembly.
Red Seal field insights
This is very common in dusty regions. Dust gets into the pedal sensor connector, causing a "micro-short." Clean the connector with contact cleaner before replacing the expensive pedal assembly.
Same code keeps coming back?
That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.
Read before you touch anything
- This is general reference information, not a repair manual. It is for trained, qualified technicians.
- Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
- Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
- You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
- Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.
Track this across your whole fleet
This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.
Start your free trialRelated Isuzu fault codes
- P1421Frequent Regens / DPF Face Loading
- P1237White Smoke / Misfire Cylinder 1
- P2453Forced Idle / DPF Warning
- P1095Sudden Engine Shutdown
- P2463Flashing DPF Light / 40% Torque Derate
- P1093Engine Shuts Down Under Load / Hard Restart
- P0673Hard Cold Start / White Smoke / Glow Plug Light Flashing
- P0404Lack of Power / Black Smoke
- P0402Excessive black smoke; Poor fuel economy.
- P0401Engine Pinging / Hesitation at Low RPM