Link-Belt Fault Code
Free · no signupP0016
Engine cranks but won't start; Rough idle; Sudden loss of power or "limp mode."
System
Not specified
Symptom
Engine cranks but won't start; Rough idle; Sudden loss of power or "limp mode."
Diagnosis & fix steps
Crank/Cam Position Correlation.
LOGIC: The ECM detects that the timing marks between the Crankshaft and Camshaft sensors do not align.
ACTION: 1. Inspect both sensor connectors for moisture.
2. Check for loose reluctor wheel.
3. Verify engine timing/belt/gear alignment.
FIX: Replace faulty Crank or Cam sensor; adjust mechanical timing; repair harness "noise" or interference.
Red Seal field insights
This code often pops up after a timing belt or gear train repair. If the sensors are new, double-check that the tone wheel wasn't installed backward or "one tooth off."
Same code keeps coming back?
That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.
Read before you touch anything
- This is general reference information, not a repair manual. It is for trained, qualified technicians.
- Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
- Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
- You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
- Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.
Track this across your whole fleet
This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.
Start your free trialRelated Link-Belt fault codes
- P0087Bogs under load; Hard start; White smoke on pull.
- B0121Weak/slow hydraulics; Pump won't destroke.
- P0088Engine "limp mode"; Hard knocking; Potential shutdown.
- P0121Stuck at low idle; No response to RPM dial.
- P0234Turbo "Whine" or "Whoosh" sound; Sudden loss of power; Black smoke.
- P0335Cranks/No start; Sudden stall; Tach at zero.
- P0404Low power; High fuel use; Black smoke.
- P0500Speedo reads zero; Erratic travel behavior.
- P0540Hard start in cold; White smoke; Battery drain.
- P2002Frequent regens; Soot warning; Power derate.