Sinotruk Fault Code

Free · no signup

P2122 / SPN 91 FMI 4

Dead Throttle Pedal / Engine at 1,000 RPM

System

Throttle / Cab

Symptom

Dead Throttle Pedal / Engine at 1,000 RPM

Diagnosis & fix steps

LOGIC: Accelerator Pedal Position Sensor 1 Signal Voltage Low. ACTION: Inspect the 6-pin pedal connector under the dashboard. Check 5V reference supply and ground return from ECM; monitor Sensor 1 voltage sweep (spec: 0.5V idle to 4.5V full throttle).

Red Seal field insights

Limp Throttle: Sinotruk uses dual potentiometers inside the electronic pedal. A single channel loss locks engine speed to a safe fast-idle limp mode to permit clearing the road.

Same code keeps coming back?

That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.

Book an uptime review

Read before you touch anything

  • This is general reference information, not a repair manual. It is for trained, qualified technicians.
  • Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
  • Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
  • You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
  • Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.

Track this across your whole fleet

This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.

Start your free trial

Related Sinotruk fault codes

← All Sinotruk fault codes