Bobcat Fault Code

Free · no signup

04-14

Engine Shuts Down Automatically in 30 Seconds

System

Engine / Oil

Symptom

Engine Shuts Down Automatically in 30 Seconds

Diagnosis & fix steps

LOGIC: Engine Oil Pressure Sensor Voltage Out of Range Low. ACTION: Shut down immediately. Verify oil level on dipstick. Install mechanical gauge in oil galley (spec: >15 PSI at idle). If mechanical pressure is good, replace the 1-wire/2-wire pressure switch on the block.

Red Seal field insights

Vibration Switch Failure: The mechanical diaphragm inside the single-pin engine oil pressure switch ruptures from engine block vibration, leaking oil into the spade terminal and grounding out.

Read before you touch anything

  • This is general reference information, not a repair manual. It is for trained, qualified technicians.
  • Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
  • Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
  • You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
  • Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.

Track this across your whole fleet

This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.

Start your free trial

Related Bobcat fault codes

← All Bobcat fault codes