Caterpillar Fault Code
Free · no signup1250-9
Remote Control Inop / Lag
Variant 1
System
Network
Symptom
Remote Control Inop / Lag
Diagnosis & fix steps
LOGIC: Remote Control Receiver Abnormal Update.
ACTION: Check CAT Data Link wiring for 120 Ω resistance. Ensure receiver has unobstructed line-of-sight.
Red Seal field insights
Logic: ECM lost communication heartbeat with the receiver. Common on "Command for Excavation" builds.
Variant 2
System
Electrical
Symptom
Remote Control Comm: Abnormal Update
Diagnosis & fix steps
LOGIC: Loss of CAN heartbeat from RC module.
ACTION: Check CAT Data Link wiring and 120-ohm terminating resistors.
Red Seal field insights
This code triggers when the machine loses "eyes" on the remote interface; common on line-of-sight units.
Same code keeps coming back?
That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.
Read before you touch anything
- This is general reference information, not a repair manual. It is for trained, qualified technicians.
- Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
- Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
- You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
- Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.
Track this across your whole fleet
This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.
Start your free trialRelated Caterpillar fault codes
- 247-9Dash Blank / Limp Mode
- 3413-5Fuel Lift Pump Failure
- 3510-3Multiple Faults
- MID 036 CID 0168 FMI 01Multiple Sensor Faults / Monitor Blinks
- SPN 168 FMI 1Slow Crank / ECM Reset
- 12Coolant Level Sensor
- 13Fuel Temperature Sensor
- 110-3Temp Gauge Maxed / High Idle.
- 15Injection Actuation Pressure (IAP)
- 110-04The ECM detects a "Short to Ground." Engine may enter an immediate severe derate or shutdown to prevent perceived overheating.