Klemm Fault Code

Free · no signup

SPM Warning

Drill Stops. The machine won't allow rotation or feed in "SPM" mode.

System

Not specified

Symptom

Drill Stops. The machine won't allow rotation or feed in "SPM" mode.

Diagnosis & fix steps

LOGIC: Special Protective Mode (SPM) safety violation. ACTION: Verify the "Interlocking Guard" (safety cage) is fully closed and the magnetic sensor is aligned.

Red Seal field insights

Red Seal Fix: Klemm rigs are very strict about the safety cage. If the cage is slightly bent from a rod-handling mishap, the magnet won't seat. A quick "field fix" is checking the proximity sensor gap—it should be under 4mm.

Same code keeps coming back?

That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.

Book an uptime review

Read before you touch anything

  • This is general reference information, not a repair manual. It is for trained, qualified technicians.
  • Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
  • Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
  • You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
  • Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.

Track this across your whole fleet

This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.

Start your free trial

Related Klemm fault codes

← All Klemm fault codes