Suzuki Fault Code
Free · no signupP0171
Lean Hesitation / White Spark Plug Porcelain
System
Fuel / Metering
Symptom
Lean Hesitation / White Spark Plug Porcelain
Diagnosis & fix steps
LOGIC: Fuel Trim System Too Lean (Bank 1).
ACTION: Check for cracked intake air plenum boots downstream of air filter under bed. Measure fuel pressure at delivery line (spec: ~2.8–3.2 bar); clean varnished 12-hole micro fuel injector tips.
Red Seal field insights
Sub-Bed Airbox Disconnect: Routine air filter changes under the truck bed often leave the accordion rubber intake hose disconnected or torn on the back side, drawing unmetered false air.
Same code keeps coming back?
That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.
Read before you touch anything
- This is general reference information, not a repair manual. It is for trained, qualified technicians.
- Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
- Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
- You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
- Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.
Track this across your whole fleet
This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.
Start your free trialRelated Suzuki fault codes
- P0219MIL Flashing
- Code 42 / P0335Crank No-Start / Tachometer Needle Dead
- P0300Engine Shudders Under Load / Flashing CEL
- Code 34 / P0340Extended Cranking / Crank No-Start Cold
- P0301Dead Cylinder 1 / Exhaust Stumble
- Code 31 / P0105Rough Low Idle / Stalling When Shifting
- P0335Hard Start
- Code 24 / P0500Speedometer Inop / Engine Surges at Coast
- P0400Knock on Acceleration / Flat Mid-Range
- Code 21 / P0120Hesitation Off-Idle / Bucking on Accel