Liebherr Fault Code

Free · no signup

SPN 520290 FMI 14

Free-Fall Winch Interlock Active

System

Hydraulics / Winch

Symptom

Free-Fall Winch Interlock Active

Diagnosis & fix steps

LOGIC: Controlled Free-Fall Brake Pressure Sensor Implausible. ACTION: Check brake pressure sensor zero-point offset key-on engine off (spec: 0.5V / 0 bar). Perform a hydraulic pressure test on the wet clutch brake release port.

Red Seal field insights

Safety Override: Prevents accidental clutch release; the crane controller blocks free-fall arming if residual hydraulic release pressure is detected while brakes are set.

Same code keeps coming back?

That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.

Book an uptime review

Read before you touch anything

  • This is general reference information, not a repair manual. It is for trained, qualified technicians.
  • Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
  • Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
  • You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
  • Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.

Track this across your whole fleet

This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.

Start your free trial

Related Liebherr fault codes

← All Liebherr fault codes