Other Fault Code

Free · no signup

E02 / E03

Alarm buzzer; Winch-up and Telescope-out cut off.

System

Sany LMI

Symptom

Alarm buzzer; Winch-up and Telescope-out cut off.

Diagnosis & fix steps

Boom Angle Sensor Fault. LOGIC: E02 (Signal too high) or E03 (Signal too low). The LMI is not seeing the 4-20mA signal from the inclinometer.

Red Seal field insights

Sany angle sensors are often mounted in a blue or silver box on the side of the base section. Because Sany machines often operate in high-vibration environments, the internal cable connector can vibrate loose. Check the "pin fitment" before replacing the sensor.

Same code keeps coming back?

That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.

Book an uptime review

Read before you touch anything

  • This is general reference information, not a repair manual. It is for trained, qualified technicians.
  • Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
  • Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
  • You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
  • Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.

Track this across your whole fleet

This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.

Start your free trial

Related Other fault codes

← All Other fault codes