Caterpillar Fault Code
Free · no signup2266-7
Pump #2 Outlet Pressure Sensor: Not Responding
Variant 1
System
Hydraulic
Symptom
Pump #2 Outlet Pressure Sensor: Not Responding
Diagnosis & fix steps
LOGIC: Static signal on Pump 2.
ACTION: Check for air in the pilot lines or a failed transducer internal diaphragm.
Red Seal field insights
Usually caused by a "slug" of debris or air lock after a hose replacement.
Variant 2
System
Hydraulic
Symptom
Erratic Main Pump Response
Diagnosis & fix steps
LOGIC: Pump #2 Outlet Pressure Sensor Not Responding.
ACTION: Perform "Pressure Sensor Calibration" in CAT ET. If it fails, check for a blocked sensor orifice.
Red Seal field insights
Specs: Signal should be 0.5V at rest (atmospheric) and up to 4.5V at full stroke.
Same code keeps coming back?
That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.
Read before you touch anything
- This is general reference information, not a repair manual. It is for trained, qualified technicians.
- Fault codes, meanings and procedures vary by model, serial number and software version. Confirm the code and the procedure against the manufacturer's service manual before acting.
- Follow the OEM service manual, torque specs and your site's safety procedures: lockout/tagout, block raised equipment, relieve hydraulic, fuel and air pressure, and let hot systems cool.
- You use this information at your own risk. Adventure Mechanical and AM Fleet Integrity accept no liability for damage, injury, downtime or loss arising from its use.
- Not affiliated with or endorsed by any manufacturer. Brand names are used only to identify the equipment a code applies to.
Track this across your whole fleet
This code is free to read. AM Fleet Integrity lets your team log fault codes against assets, plus the full fault-code library, QR operator reporting, PM scheduling and predictive alerts. Start free — no credit card required.
Start your free trialRelated Caterpillar fault codes
- 2265-7Pump #1 Outlet Pressure Sensor: Not Responding
- 600-4Hydraulic Temp Gauge High
- 735-6Heavy Lift Solenoid: Current Above Normal
- E1239Heavy Lift Solenoid: Current Above Normal
- 2348-9Gauge Cluster Flash / Loss of Controls
- 24Engine Oil Pressure Sensor
- 2458-2No Regeneration. The machine refuses to start a "Parked Regen"; Service light flashes.
- 215V / 8V Sensor Power Supply
- 247-9Dash Blank / Limp Mode
- 1658-4Right Joystick Thumbwheel: Voltage Below Normal