Question 1

What does Suzuki fault code Code 13 / P0130 mean?

Accepted Answer

Code 13 / P0130 (Fuel / Oxygen): High Fuel Consumption / Black Tailpipe Soot Fix: LOGIC: Heated Oxygen Sensor 1 Circuit Inactive or Shorted.

ACTION: Disconnect single-wire or 4-wire O2 sensor pigtail at exhaust downpipe under seat. Measure heater resistance across white wires (spec: ~5–7Ω); check signal output while hot (should swing rapidly 0.1V to 0.9V).

Question 2

What does Suzuki fault code Code 14 / P0115 mean?

Accepted Answer

Code 14 / P0115 (Cooling / Thermal): Floods on Hot Restart / Fast Idle Sticks Fix: LOGIC: Engine Coolant Temperature (ECT) Sensor Signal High / Open.

ACTION: Access thermostat housing under bed access hatch. Disconnect 2-pin ECT sensor. Test thermistor resistance (spec: ~2.0k–3.0kΩ at 20°C, drops to ~300Ω hot); verify 5V reference wire from ECU.

Question 3

What does Suzuki fault code Code 15 / P0117 mean?

Accepted Answer

Code 15 / P0117 (Cooling / Thermal): Radiator Fan Runs Continuously / Hard Start Fix: LOGIC: Engine Coolant Temperature Sensor Signal Short to Ground.

ACTION: Measure ECT signal pin resistance to chassis ground (must be infinite with sensor unplugged). Inspect sub-harness where it passes over the aluminum intake manifold runner for melted loom.

Question 4

What does Suzuki fault code Code 24 / P0500 mean?

Accepted Answer

Code 24 / P0500 (Speed Sensing): Speedometer Inop / Engine Surges at Coast Fix: LOGIC: Vehicle Speed Sensor (VSS) Reed Switch Signal Missing.

ACTION: Remove instrument cluster or transmission tailhousing speed pickup. On cable-driven models, test the magnetic reed switch behind speedometer head; on electronic models, check 3-pin Hall-effect sensor.

Question 5

What does Suzuki fault code Code 34 / P0340 mean?

Accepted Answer

Code 34 / P0340 (Timing / Cam): Extended Cranking / Crank No-Start Cold Fix: LOGIC: Camshaft Position Sensor Signal Loss.

ACTION: Disconnect CMP sensor on top rear of cylinder head. Check 3-pin plug for engine oil wicking through sensor body. Measure sensor power, ground, and square-wave digital output during cranking.

Question 6

What does Suzuki fault code P0171 mean?

Accepted Answer

P0171 (Fuel / Metering): Lean Hesitation / White Spark Plug Porcelain Fix: LOGIC: Fuel Trim System Too Lean (Bank 1).

ACTION: Check for cracked intake air plenum boots downstream of air filter under bed. Measure fuel pressure at delivery line (spec: ~2.8–3.2 bar); clean varnished 12-hole micro fuel injector tips.

Question 7

What does Suzuki fault code P0219 mean?

Accepted Answer

P0219 (Engine): MIL Flashing Fix: LOGIC: Engine Over-speed Condition.

ACTION: Check for a "stuck" throttle cable or a failed gear position sensor.

Question 8

What does Suzuki fault code P0300 mean?

Accepted Answer

P0300 (Ignition / Misfire): Engine Shudders Under Load / Flashing CEL Fix: LOGIC: Random / Multiple Cylinder Misfire Detected.

ACTION: Pull individual direct ignition stick coils. Inspect rubber boots for white pinhole dielectric puncture marks and rust. Inspect spark plug wells for engine valve cover oil pooling.

Question 9

What does Suzuki fault code P0301 mean?

Accepted Answer

P0301 (Ignition / Misfire): Dead Cylinder 1 / Exhaust Stumble Fix: LOGIC: Cylinder 1 Misfire Detected.

ACTION: Swap Coil 1 to Cylinder 2. If misfire follows coil, replace Diamond/Denso coil pack. If misfire remains on Cyl 1, measure compression (must be >170 PSI; minimum 130 PSI) and inspect valve lash.

Question 10

What does Suzuki fault code P0335 mean?

Accepted Answer

P0335 (Engine): Hard Start Fix: LOGIC: CKP Circuit.

ACTION: Inspect sensor tip for metallic shavings/debris.

Suzuki Fault Codes

Ready to take control of your fleet maintenance?

Other manufacturers

Code	System	Symptom	Full fix
Code 13 / P0130	Fuel / Oxygen	High Fuel Consumption / Black Tailpipe Soot	View fix
Code 14 / P0115	Cooling / Thermal	Floods on Hot Restart / Fast Idle Sticks	View fix
Code 15 / P0117	Cooling / Thermal	Radiator Fan Runs Continuously / Hard Start	View fix
Code 24 / P0500	Speed Sensing	Speedometer Inop / Engine Surges at Coast	View fix
Code 34 / P0340	Timing / Cam	Extended Cranking / Crank No-Start Cold	View fix
P0171	Fuel / Metering	Lean Hesitation / White Spark Plug Porcelain	View fix
P0219	Engine	MIL Flashing	View fix
P0300	Ignition / Misfire	Engine Shudders Under Load / Flashing CEL	View fix
P0301	Ignition / Misfire	Dead Cylinder 1 / Exhaust Stumble	View fix
P0335	Engine	Hard Start	View fix
P0400	EGR System	Knock on Acceleration / Flat Mid-Range	View fix
P0420	Emissions / Exhaust	Check Engine Light Solid / Tailpipe Odor	View fix
P0505	Air / Idle	Engine Dies at Red Lights / Surges 1500 RPM	View fix
P0605	Engine Control	Engine Won't Rev Past 2000 RPM / CEL Solid	View fix
P1614	Safety / Immobilizer	Engine Cranks But Refuses to Fire / Key Light	View fix