19 Toyota diagnostic codes on file — with the full diagnosis, repair steps, and field insights open to read free, no signup required.
Disclaimer: General reference information for trained, qualified technicians only. Codes and procedures vary by model, serial number and software version. Always follow the manufacturer's service manual and your site's safety procedures. Use at your own risk. Not affiliated with or endorsed by any manufacturer.
| Code | System | Symptom | Full fix |
|---|---|---|---|
| P0087 | Fuel System | Engine Cuts Out During Full Acceleration | View fix |
| P0087 | Fuel | Engine stalls under load; Limp mode; Hard starting. | View fix |
| P0087 | Fuel System | White Smoke / No Start | View fix |
| P0088 | — | Engine "knocking" sound; Sudden shutdown; Rail pressure gauge (if equipped) pins high. | View fix |
| P0093 | — | Severe power loss; Engine stalls under load; Large fuel leak detected warning. | View fix |
| P0093 | Fuel / HPCR | Engine Limp Mode / Cuts Out Under Load | View fix |
| P0093 | Fuel System | Engine Limp Mode / Cuts Out Under Load | View fix |
| P0093 | Fuel | Severe power loss; Engine may shut down while driving. | View fix |
| P0191 | Fuel System | Limp Mode / Surge. Engine lacks power under load; Rail pressure erratic. | View fix |
| P0401 | Emissions | CEL on; Reduced power; Excessive smoke. | View fix |
| P0455 / P0456 | Emissions | Fuel smell near rear; CEL after refueling. | View fix |
| P1229 | Fuel / Pump | Check Engine Solid / Severe Power Cap | View fix |
| P1264 | — | Engine misfire; Rough running; White smoke; Loss of power. | View fix |
| P1415 / P1416 | Fuel | Hard starting in heat; Loss of power. | View fix |
| P1604 | Starting / Engine | Engine Cranks Long / Intermittent Stall | View fix |
| P1604 | Starting / System | Engine Cranks Long / Starts and Dies | View fix |
| P244B | Emissions / DPF | DPF Full Warning / High Fuel Consumption | View fix |
| P2458 | — | Frequent DPF warning; Engine derate; Fuel smell in oil. | View fix |
| P2463 | Emissions / DPF | DPF Warning Lamp / Limp Mode Active | View fix |
Same codes keep coming back?
That's a program problem, not a part problem. Book a 30-minute uptime review with Grant, a Red Seal Heavy Duty Technician.
AM Fleet Integrity gives you QR-code operator reporting, preventive maintenance scheduling, and predictive alerts in one place. Start your 14-day free trial — no credit card required.
Start your free trial